If your order is time sensitive, please use one of the expediated options on the check out page but please read our shipping advisory page. Orders accepted 24/7/365 via the website. Toll Free Tech Support Hours: Mon-Fri, 10am to 4pm, PST. We also have an alternate phone number in case the above has problems: 1(877)782-3488. Thank you! :-)
"If there be any among us who [disagree], let them stand undisturbed as monuments of the safety with which error of opinion may be tolerated, where reason is left free to combat it." Thomas Jefferson, March 4, 1801
Very low stock; discontinued part; Orders limited to stock on hand This 90° nut will work on the 1/2" bulkhead fittings (aka tank adapters). Instead of coming straight out from the fitting, this nut forms a 90° bend. Takes 1" in the slip socket end. Dimensions are: Overall length 2.72", Overall Width 1.85" Clear fitting. In stock, but currently at low levels. (Only fits the old 1/2" bulkheads we used to sell. It somewhat fits the 9105 series of 1/2" bulkheads we currently sell. It'll start the thread and go on about 1/4 of the way and then bind up. Is used with a thread sealant it could work depending on your situation.)
